How To Design A Shell And Tube Heat Exchanger

When designing a shell and tube heat exchanger, some several major steps and factors typically need to be considered:
 

Determine the design requirements:
Heat load: specify the amount of heat to be exchanged.
Fluid inlet and outlet temperatures: Including inlet and outlet temperatures of tube and shell and tube fluids.
Fluid properties: such as density, specific heat capacity, viscosity, corrosivity, etc.
Operating pressure and temperature range.
Selection of heat exchanger type:
According to the nature of the fluid, pressure and temperature conditions, cleanliness requirements, etc., to determine whether to use a fixed tube and plate type, U-tube type, floating head type.
Calculate the heat transfer coefficient:
Calculate the heat transfer coefficients for tube and shell processes respectively, taking into account the fluid flow rate, degree of turbulence, fouling thermal resistance and other factors.

 

How to Design a Shell and Tube Heat Exchanger 1


Preliminary estimation of heat transfer area:
According to the heat load and heat transfer coefficient, make a preliminary estimate of the required heat transfer area.
Determine the basic structural parameters of the heat exchanger:
Tube diameter and tube length: Select the appropriate tube diameter and tube length according to the flow rate and pressure drop requirements.
Tube spacing and arrangement: common triangle and square arrangement.
Shell diameter: according to the number of tubes and arrangement to determine.
Calculate pressure drop:
Calculate the pressure drop of the tube and shell fluids separately to ensure that it is within the permissible range.
Account for heat transfer area and heat transfer coefficient:
Recalculate the heat transfer area and heat transfer coefficient based on the determined structural parameters.

 

How to Design a Shell and Tube Heat Exchanger 2


Strength calculations:
Perform strength calculations on the heat exchanger shell, header, tube plate, etc. to ensure that it can withstand the working pressure.
Seal and connection design:
Design reasonable connection of tube plate and tube, connection of shell and head to ensure sealing performance.
Accessory design:
Including inlet and outlet receivers, folding plate, anti-flush plate, support and so on.
Drawing and preparation of design documents:
Provide detailed design drawings and related technical documents, including material list, manufacturing process requirements, etc.

 

You Might Also Like

Send Inquiry